If you are building or buying a new home in Florida, one of the first questions you may hear is “block or frame?” Many Floridians have strong opinions about it. The honest answer is that both concrete block and wood frame homes can be designed to meet Florida’s wind code, and both can fail if they are poorly built or poorly connected. This guide explains how each wall system works, how the Florida Building Code treats them, what post-storm research actually says, and how termites, moisture, insurance and cost come into the decision.
How Each Wall System Is Built
Concrete block (CMU)
A concrete block home has exterior walls made of concrete masonry units (CMU, or “block”). The blocks have hollow cells. In a wind-resistant design, some cells get steel reinforcing bars and are filled with concrete or grout. A concrete tie beam (or bond beam) is poured along the top of the walls, and the roof framing is anchored to it with metal connectors.
FEMA’s Home Builder’s Guide to Coastal Construction fact sheet on masonry details (FEMA 499, 2005) says masonry must be reinforced according to the building plans, and that coastal homes typically need more reinforcing than inland homes. It also stresses that a properly connected load path from the roof to the foundation is crucial in coastal areas. The block is only part of the system. The reinforcing, filled cells, beam and connectors tie it together. Block walls are usually finished with stucco and paint outside and drywall on furring strips inside.
Wood frame
A wood frame home has exterior walls built from wood studs covered with structural wood panels (plywood or OSB) called sheathing. The sheathing, its nailing pattern and metal straps or hold-downs work together to resist wind pushing on the walls and lifting the roof. A weather barrier such as housewrap goes over the sheathing, followed by siding or stucco. FEMA’s coastal fact sheet on housewrap (FEMA 499, 2005) calls it “a good choice for coastal homes.” Frame homes depend on the same continuous load path from roof to foundation.
How the Florida Building Code Treats Both
Florida’s code does not favor one wall material over the other. It sets the wind loads a home must resist and lets the designer choose an approved method for meeting them.
Section R301.2.1.1 of the 8th Edition (2023) Florida Building Code, Residential, says that where the ultimate design wind speed is 115 mph or more, concrete, masonry, wood and steel buildings must be designed for wind using one or more listed methods. They include the AWC Wood Frame Construction Manual, the ICC Standard for Residential Construction in High-Wind Regions (ICC 600) for concrete and masonry walls, the national load standard ASCE 7, and the Florida Building Code, Building. The MAF Guide to Concrete Masonry Residential Construction in High Wind Areas is also allowed, but only at lower wind speeds (130 mph in Exposure B, 110 mph in Exposure C).
The same section still sends roof sheathing to Section R803, roof coverings to Chapter 9, and windows and doors to Section R609. So a block home and a frame home on the same lot face the same design wind speed, roof sheathing rules and window rules.
Both systems are in active use. A Florida Building Commission staff analysis of a 2023 declaratory statement (DS 2023-044) involved an engineering firm whose base plans for high-volume Florida builders were wood-framed homes.
Wind speeds, the wind-borne debris region and opening protection are covered in our guide to building for hurricanes in Florida, so we won’t repeat them here. The 9th Edition (2026) of the code is scheduled to take effect on December 31, 2026, so ask your builder which edition your permit falls under.
What Storm Research Says About Hurricane Performance
You will hear stories about block homes “standing when frame homes didn’t,” and the reverse. Here is what published research supports.
Code era and connections matter more than slogans. After Hurricane Ian in 2022, FEMA’s Mitigation Assessment Team reported that it did not observe wind-related structural damage to any post-Florida Building Code homes. The International Code Council’s February 2024 summary of that report gives a Lee County example: a 2022 home in St. James City with no visible damage, half a mile from a 1990 home that suffered severe structural damage. The summary does not break results down by wall material.
Well-built wood frame homes have a good structural record. A 1998 NIST review of wood frame housing in selected hurricanes and earthquakes found that wood frame houses “performed well with relatively few instances of structural failures,” and tied failures mainly to poor construction and code noncompliance.
Masonry also depends on details. FEMA’s masonry fact sheet notes that gable ends are more prone to damage than hipped roofs and must be braced for both inward and outward forces. It also warns that moisture getting into large cracks can corrode the reinforcing steel and lead to cracking and spalling.
The roof is often the weak point. FEMA’s Ian findings, as summarized by the ICC, describe widespread roof covering damage and say newer roof coverings generally performed better than older ones, whatever the walls were made of. Our companion article on metal, shingle and tile roofs in Florida covers that.
The fair takeaway: building to the current code, with a complete load path and good inspections, matters more than wall material alone.
Termites
Florida requires termite protection on every new home, block or frame. Section R318.1 of the 8th Edition (2023) Florida Building Code, Residential, as quoted in the City of Tampa’s January 2024 technical guide, requires termite protection by registered termiticides (soil treatments, baiting systems or wood treatments) or other approved methods. When the treatment is done, the pest control company must give the building department a Certificate of Compliance stating the treatment follows Florida Department of Agriculture and Consumer Services rules. The Tampa guide says the certificate must be approved before a Certificate of Occupancy is issued.
Block walls do not make a house termite-proof. Termites are after wood, and a block home still has some: roof framing in many designs, interior walls, trim, doors and cabinets. In a frame home, the exterior walls are wood too.
- Pre-treatments don’t last forever. NAHB’s 2007 Study of Life Expectancy of Home Components estimated termite pre-treatment lasts about 12 years if the chemical barrier from construction is left intact.
- Invasive termites are spreading. A February 2026 UF/IFAS report says the Formosan subterranean termite is now established in most of Florida’s coastal counties and major urban centers.
- Ongoing protection is on the owner. Ask what treatment was used and what the renewal or service terms are.
Moisture and Mold
Florida’s heat, humidity and wind-driven rain test every wall.
Block walls absorb water. In a 2010 Building Science Corporation article on Florida block homes, building scientist Joseph Lstiburek describes walls where the stucco, the paint and the block all let water in. He recommends details such as a capillary break under the foundation, a concrete “seat” at the slab edge so rain can drain out at the base of the wall, keeping stucco out of the ground, vapor-permeable coatings, and window sills shaped to drain water outward. He also warns against foil-faced or other vapor barriers on the inside of block walls in this climate, because they can trap moisture.
Wood walls need to stay dry. A frame wall relies on its weather barrier, flashing and siding to keep water away from the sheathing and studs. Wood that stays wet can rot and becomes more attractive to termites. Flashing at windows, doors and roof-to-wall joints is critical.
Either way, details matter. Ask your builder how the wall assembly handles rain from the outside and humidity from the inside.
Insurance Considerations
Wall type can come up in insurance, but it’s not as simple as “block is always cheaper.”
Construction class. Insurers classify homes by construction type. Citizens Property Insurance Corporation, for example, has a construction definitions rule (Rule 214), which an April 30, 2026 bulletin says was amended for policies effective on or after July 1, 2026 to add fiber cement to the masonry veneer definition. Each carrier rates construction types its own way.
The wind mitigation form. Florida law (section 627.0629, Florida Statutes) requires insurers to offer discounts or credits for features that reduce wind losses, including roof-to-wall strength and wall-to-floor-to-foundation strength. Owners usually document these features with the state’s Uniform Mitigation Verification Inspection Form, OIR-B1-1802. Citizens’ March 2026 bulletin on the revised form (Rev. 04/26), required for inspections on or after April 1, 2026, lists the form’s existing features as building code, roof covering, roof deck attachment, roof-to-wall attachment, secondary water resistance and opening protection. Wall material is not one of those features.
Roof-to-wall attachment is where the wall system shows up. On a block home, the inspector looks at how the roof is anchored to the tie beam; on a frame home, at the straps or clips to the wall framing.
Credits depend on the insurer, the policy and what an inspector can verify, so no savings are guaranteed. Our article on home insurance for new construction in Florida covers the basics, and a licensed insurance agent can quote the actual difference for a specific home.
Cost and Schedule Drivers
We could not find a reliable, current source that compares the cost of block and frame homes in Southwest Florida, so we won’t give you a number. Here is what drives the difference on any given project:
- Material prices. Lumber prices move differently from block, concrete and rebar prices, so a comparison from one year may not hold the next.
- Labor. Block needs masons and concrete crews; frame needs framers. Local crew availability affects price and schedule.
- Engineering. Design wind speed, exposure and house shape (gable versus hip roof) change how much reinforcing, sheathing and hardware is needed.
- Inspections. Each system has its own inspections before walls are covered, and weather can affect timing.
- Finishes and insurance. Stucco and siding differ in cost and upkeep, and premiums are an ongoing cost.
The best comparison is a builder pricing the same plan both ways and explaining the line items that differ.
What’s Common in Southwest Florida
We could not find an official count of block versus frame homes in Lee, Charlotte or Collier County, so we can’t tell you which is more common locally.
National data shows that concrete framing is concentrated in the South. NAHB’s analysis of U.S. Census data found that 93% of single-family homes completed nationally in 2023 were wood-framed and 7% were concrete-framed. In the South, concrete-framed homes made up 11% of completions. Those figures cover the whole South, not Florida or Southwest Florida.
For what it’s worth, the plan sheets for two of Proudhouse Builders’ upcoming single-story models, the Bari and the Napoli, list concrete block construction. You can see them on our home models page.
Questions to Ask Your Builder
- Is the home block, frame or a mix (for example, block walls with framed gables)?
- Which design method and code edition is it engineered under?
- How is the roof connected to the walls?
- How do the walls handle water at windows, doors and the slab edge?
- What termite treatment is used, and what are the renewal terms?
- Will I get the documents a wind mitigation inspector will ask for?
Frequently Asked Questions
Is a concrete block house stronger than a wood frame house in a hurricane?
Not automatically. Florida’s code requires both to resist the same design wind loads, and post-storm research points to code era, connections and roof performance as major factors.
Does a block home get a lower insurance rate in Florida?
It might, depending on the insurer. Each carrier sets its own rates by construction type, and the state wind mitigation form focuses on the roof, roof-to-wall connections and openings. Ask a licensed agent to quote the specific home.
Do block homes get termites?
Yes. Block homes still contain wood, and Florida’s code requires termite protection on all new homes. That protection needs upkeep over time.
Are block homes more prone to mold?
Block walls absorb water, and Building Science Corporation has documented Florida block homes where water could not drain or dry. Frame walls have their own risks. Flashing, drainage and wall design matter most.
This article is general information, not engineering, legal or insurance advice. Confirm details for your lot with your building department, a licensed design professional and your insurance agent.
Talk With Proudhouse Builders
Weighing block against frame for a home in Southwest Florida? Proudhouse Builders plans, designs and builds homes in the region and can walk you through how a specific plan is built. Learn more on our services page, call us at (239) 321-0594, or reach out through our contact page. You bring the land, we do the rest.
Sources
- Florida Building Commission, Staff Analysis, Declaratory Statement DS 2023-044 (quotes 8th Edition (2023) FBC-Residential R301.2.1.1 and R803.2.2): floridabuilding.org/fbc/commission/FBC_0124/DEC_Statements/D…
- ICC National Technical Assistance, “Florida Adopts New Building Codes” (9th Edition effective December 31, 2026): icc-nta.org/code-update/florida-adopts-new-building-codes/
- FEMA, Home Builder’s Guide to Coastal Construction (FEMA 499, June 2005), Technical Fact Sheet No. 16, Masonry Details (copy hosted by the Louisiana Department of Energy and Natural Resources): denr.louisiana.gov/assets/docs/energy/programs/residential/c…
- FEMA, Home Builder’s Guide to Coastal Construction (FEMA 499, June 2005), Technical Fact Sheet No. 23, Housewrap (same host): denr.louisiana.gov/assets/docs/energy/programs/residential/c…
- International Code Council, Building Safety Journal, “Hurricane Ian in Florida: A Mitigation Success Story for Building Codes” (February 7, 2024), summarizing FEMA P-2342: iccsafe.org/building-safety-journal/bsj-technical/hurricane-…
- FEMA, Hurricane Ian in Florida Mitigation Assessment Team Report, FEMA P-2342 (December 2023): fema.gov/sites/default/files/documents/fema_rm-hurriance-ian…
- NIST, Summary of the Structural Performance of Single-Family, Wood-Frame Housing, NISTIR 6224 (1998): nist.gov/publications/summary-structural-performance-single-…
- City of Tampa, Technical Guide: Residential Termite Protection Requirements (updated January 12, 2024; quotes FBC-R 8th Edition R318.1): tampa.gov/sites/default/files/document/2026/technical_guide_…
- National Association of Home Builders / Bank of America Home Equity, Study of Life Expectancy of Home Components (February 2007): standards.nsf.org/higherlogic/ws/public/download/348/NAHB%20…
- UF/IFAS, “New study shows invasive termites threatening homes in Florida are spreading farther than predicted” (February 4, 2026): blogs.ifas.ufl.edu/news/2026/02/04/new-study-shows-invasive-…
- Building Science Corporation, BSI-037: “Mold in Alligator Alley,” Joseph Lstiburek (2010): buildingscience.com/documents/insights/bsi-037-mold-in-allig…
- Citizens Property Insurance Corporation, “July 2026 Rate, Rule, and Wind-Loss Mitigation Updates” (April 30, 2026): citizensfla.com/-/20260430-july-2026-rate-rule-and-wind-loss…
- Citizens Property Insurance Corporation, “Uniform Mitigation Verification Inspection Form Changes” (March 19, 2026): citizensfla.com/-/20260319-uniform-mitigation-verification-i…
- Florida Statutes, Section 627.0629 (windstorm mitigation discounts): flsenate.gov/Laws/Statutes/2025/627.0629
- NAHB Eye on Housing, “Wood-Framed Home Share Decreased in 2023,” Jing Fu (August 12, 2024): eyeonhousing.org/2024/08/wood-framed-home-share-decreased-in…
Own land in Southwest Florida?
Our team can tell you what your parcel can become. Call (239) 321-0594 or start a land review online.
Start a land review


